We all know how uncomfortable it is to be in a damp apartment. The increased level of humidity in the room damages furniture and household appliances. At the same time, even modern construction and repair technologies do not always guarantee a good internal environment. Therefore, the question of how to get rid of dampness in the house is still relevant today.
Simple Causes of Excessive Dampness
First, you need to know why the walls are damp in a private house. It will be possible to figure out what to do only after a complete analysis of the situation. As a rule, the reasons are visible. In such cases, it is not difficult to eliminate them with the help of the Department of Licenses and Inspections in Hartford, CT, which can fix the problem once and for all.
Such simple factors can explain the increased level of humidity:
- Leaks in the plumbing or sewerage system. You just need to eliminate them with insulating materials or replace pipes in problem areas.
- Insufficient ventilation. It is determined by a change in well-being – it becomes difficult to breathe. The room requires additional ventilation. Once a day, you need to arrange a 10-15 minute draft or install a hood. This is especially true for places where there is a lot of moisture by definition. This is a bathroom, kitchen, and toilet.
- Hanging a large amount of laundry to dry inside the house. It is necessary to reduce its volume, dry it outside, and in winter freeze it there.
- Flower cultivation, seedling growing. The number of indoor plants must be kept to a reasonable minimum. For seedlings, it is better to use a greenhouse.
- Failure to comply with cooking technology. At least you should not use all the burners for this at once.
- Storage of any liquid in an open way. Jars, pans, and barrels should have lids.
Often, an excessively humid background is formed due to an incorrect temperature regime in the room. The house needs to be heated, even if no one lives in it permanently during the cold season.
Hidden Factors of an Unhealthy Environment
Sometimes it is not easy or almost impossible to establish the causes of problems without involving a specialist. A licensed inspector in Hartford, CT, can advise you how to deal with dampness in a private house.
A dangerous environment can form in the house due to the following reasons:
- Plumbing or sewerage is incorrectly installed: proper insulation is not done, too much interweaving wiring, cold water, and hot water pipes are located extremely close. The way out is to replace at least one of the systems for a start.
- Lack of adequate ventilation in the basement or attic. The device of special vents is required.
- Cracks in the walls and in the base. Just covering them with cement mortar or pouring foam is not an option. You must first at least treat them with neutralizing and then moisture-repellent solutions.
- Inadequate operation of the storm drain, its clogging or damage. We’ll have to do the repair or replacement of the system.
- Breakdowns in the seams. If the house is wooden, they need to be cleaned, treated with neutralizers, and re-capped. If brick – after preliminary preparation, the seams must be cemented.
- Use in the repair or construction of substandard materials. In the first case, the solution is obvious. In the second, it is possible to lower the negative factors only with the use of additional sealing, insulation, ventilation (unless, of course, the housing is rebuilt again). The wooden house can be completely dried.
For more information regarding how you can find the proper moisture meter for all of your home inspection needs, contact the Connecticut home inspection license service in Hartford, CT, today!
